Page 17 - OWL Intuition Manuals

• Ensure that no conductors are left protruding outside the central space enclosed by the backplate.
• Please ensure that all installations comply with the current IEE regulations.
• If anything is unclear then please consult the heating system manufacturers instal-
lation instructions before making these connections. 13. Fit Temperature Sensor cable & Safety Cover -
Check all of the wiring is safely attached to the appropri- ate backplate terminals and the screws are tight. Fit the white multipole Temperature Sensor cable connector
to the back of the Tank Sensor (it will only fit one way around). Then fit the Safety Cover by clipping it into place over the wiring terminals with the Temperature Sensor cable exiting at the appropriate point.
14. Complete the installation by mounting the Tank Sensor
to the backplate. To do this engage the Tank Sensor on
the lugs at the top of the backplate, then carefully swing
the Tank Sensor down and push it carefully back into its plug-in terminal connectors. Locate over the captive screws at the base of the backplate and tighten them so that the Tank Sensor is locked into position.
15. Existing Programmer / Time Clock - any existing hot water programmer or time clock is now redundant. You should either program it to be permanently on (24/7) or preferably remove it, ensuring that the two wires it was switching are safely electrical-
Temperature Sensor Connector
© 2 Save Energy Limited 2014 17