Page 10 - OWL Intuition Manuals

4. Remove the back-up battery isolating tab by carefully pulling it away from back of the Relay Unit.
5. Complete the physical installation by mounting the Relay Unit to the backplate. To do this engage the Relay Unit on the lugs at the top of the backplate, then carefully swing the Relay Unit down and push it carefully back into its plug-in terminal connec- tors. Locate over the captive screws at the base of the backplate and tighten them so that the Relay Unit is locked into position.
STEP TWO - Install Network OWL
• •
If you are adding heating controls to an existing Intuition installation then please jump to STEP FOUR - Log in and follow Wizard.
If this is a new Intuition installation then you will first need to install the Network OWL
(supplied separately). For full details please refer to the Network OWL installation guide supplied with that product, however a summary of the steps are listed below:
10
© 2 Save Energy Limited 2014
1. 2. 3. 4.
Connect Ethernet cable between spare active LAN port on your broadband Inter- net router and the Network OWL.
Plug the power supply into the mains and insert the DC jack connector into the base of the Network OWL.
Wait until the green LED on the top of the Network OWL is flashing with a “triple blip” pattern. This should not normally take longer than 2 minutes.
Do NOT proceed to STEP THREE until this flashing pattern is observed.