Page 6 - OWL Intuition Manuals

click “Next”.
• Adjust consumption Voltage and Power Factor settings to measured values if available.
If in doubt leave the default values (Voltage = 230; Power Factor = 1.0) and click
“Next”.
• Ensure message “Device successfully added to your Intuition system.” is displayed.
• Click the “Finish” button.
• Unless you have further Intuition devices to install / configure then click the “Finish”
button.
• Click the “OK” button to close the Wizard. The web dashboard will then automatically
refresh itself and you should now have an Electricity widget within the web dashboard, although the live reading will be zero at this stage until the Sensor is correctly at- tached in the next step.
STEP FOUR - Install Transmitter and attach Sensors IMPORTANT:
• •
• •
You must ensure that the Sensor is ONLY around the live core and NOT around a sheathed cable containing live, neutral and earth.
The Sensor must be a loose fit onto the cable.
Locate the supply cables between your electricity meter and consumer unit (fuse box). See diagram on next page.
Using the latch, clamp the Sensor around the insulated Live cable going into the meter
6
© 2 Save Energy Limited 2014